Bissell SpotBot Pet Control Panel Replacement

Автор: Anthony Bonvino
  • Комментарии: 2
Bissell SpotBot Pet Control Panel Replacement

Сложность

Moderate

Шаги

10

Необходимое время

15 минут

Введение

This is a guide on how to replace the spiral brushing system on a bissell spotbot pet. Use this if your spiral brushing system is not working properly.

Инструменты

  1. SEjADpJYXnBAr2IF

    • Start here.

    note to ifixit: we cannot edit the titles of each step

    Anthony Bonvino -

  2. cEkkqu3OoNNDicV1

    • Remove the container on the right side of the vacuum.

  3. MVyBI5k4glHNK5s6
    MVyBI5k4glHNK5s6
    hwZk5XCYDImFZQi6

    • Lift the tap on top of the vacuum, and then remove the container on the left side of the vacuum.

  4. RpZwteamvg2cYCYG

    • Remove the left container of the vacuum.

  5. UXvP5LjDdbHRVXDu

    • Remove the four screws on the top of the device.

  6. vB2YBoXIQDsD5lqq

    • Lift the top of the device off once the screws are removed.

  7. yOD561IGMMFB3RaV

    • Unplug the ribbon cable from the motherboard.

  8. BCRdSeO3UvTIyCWT

    • Separate the top piece and flip it upside down.

  9. gBcDU6FeBlmYArWr
    gBcDU6FeBlmYArWr
    PaPNDyARwkUybChb

    • Remove the screws holding the motherboard in place.

  10. TAeXxsTUNgtrpU5W
    TAeXxsTUNgtrpU5W
    wUBnqyaHOADevTF5

    • Remove the motherboard from the top piece. Repair or replace the motherboard if it is faulty.

Заключение

To reassemble your device, follow these instructions in reverse order.

Автор

Anthony Bonvino

Участник c: 27/09/17

437 Репутация

Один комментарий

Where can I buy the part?

Sue Loberger -