Motorola Razr V3 Primary Speaker Replacement

Автор: Matthew Cristler

Комментарии: 0

Motorola Razr V3 Primary Speaker Replacement

Сложность

Moderate

Шаги

Необходимое время

30 минут

Введение

In this guide, you will be installing the speaker that is on the bottom of the phone. This speaker is used to make speaker phone calls, play ringtones, and other phone sounds.

Инструменты

Шаг 1

Remove the back cover by pressing down the silver button.
Pull the cover away from the phone.

Шаг 2

Remove the battery by pushing down on the top and pulling it away from the phone.

Шаг 3

Remove the SIM card by pulling it toward the top of the phone with your thumb.

Шаг 4

Unscrew the two 5mm T6 Torx screws form the phone.

Шаг 5

Pry open the back of the phone using the spudger. There are four clips, one on the left, one on the right, and two on the bottom of the phone.
You can rotate the phone left and right to get easier access while prying.
Make sure to fold back of phone down (or left depending on your orientation) after separating from body as there is ribbon connecting the back to the phone's body which can be ripped if pulled the wrong way.
The tab as well as the plastic clips are fragile, be careful when using them.

Шаг 6

Using tweezers, disconnect the copper ribbon on the left side of the phone by pulling it up from the circuit board.
The clear part below the circuit board is the antenna.

Шаг 7

Remove the antenna by pushing in the tabs on the sides with the spudger, and pulling it out.
These clips are also fragile.
When reassembling, make sure the copper piece of the antenna is properly inserted between the two copper clips that stick up from the phone.